Glory on Earth
|Glory on Earth|
Technical Stage Department
The technical stage department facilitated the creative intention and vision of both designer and AV designer primarily in providing the hanging elements required for scenery and equipment. Primarily these included but were not limited to: three incense thuribles, two "parchment" flats, one archway flat, one black border, three drop bars with projectors, and one stain glass window.
Other scenery elements included one set of treads, two pieces of steel deck (one at 1000MM, one at 1500MM), two church pews (cut in half from one complete pew), a section of MDF flooring, as well as two sets of seating bank SR and SL.
Cross bars were put in across from catwalk 3 to the US wall in order to hang the thuribles and the stain glass window. Hung with 2mm nylon black cord, each thurible had a different elevation. The stain glass window had an alloy frame with a rivet, which allowed for a loop of dyneema cord to be tied back onto itself using a truckers witch. Figure of eight loops were added at three equidistant points in the dyneema loop, allowing for rigging points to be tied to cross bars overhead.
In order to hang the two parchment flats (approx. 5000MM in width) below catwalk 2 SR and SL, a 4M scaff bar was dead hung to the catwalks beams. Using flying irons, shackles, grommets, and 1500MM drifts, the parchment flats were suspended above the seating bank.
The archway flat was screwed into the floor DS and kept aright with two 4M drifts through the frame of the flat, two ring plates, shackles and two turnbuckles in order to apply tension to the drifts.
The projection drop bars were connected to catwalk 2's beams and then a crossbar connected the 4 sets of drop bars to each other, providing multiple points for AV to project from.
See below for pictures that correlate with the description of processes above.